1. Place your
MITI-RHINO Immobilizer on the ground behind the rear wheel
with the bolt tube facing away from the motorcycle. Insert
the Secur-Key into the bolt tube, push in while rotating
the key until the Secur-Bolt's machined head indexes into
the key. Rotate the Secur-Key counter clock-wise until you
are able to fully open the inner Immobilizer jaw. Leave the
key in place.
2. Check
to insure that the wheel has no protruding obstacles which
would prevent the immobilizer from being attached. If so
you may have to boot the front wheel. Generally wheels have
openings which enable the immobilizer jaws to come together
once tightened. Solid rims can be booted and the immobilizers
jaws will not touch on the ends.
3. Pick
up Immobilizer with both hands, or as an alternative, place
the bottom of the stand on the ground or pavement directly
in front of the wheel you wish to attach the immobilizer
to.
Then follow steps 4,5, 6 and 7.
4. While
holding the Immobilizer arms open, slide the immobilizer
arms tips (ends) along the inside and outside of the tire
and wheel until you feel the inside tip fall into place between
the wheels spokes. Visually check or feel with fingers to
insure that the immobilizers arms tips are in place and
engaged within the wheel between the spokes of the wheel.
If the immobilizer arms tips are not properly engaged or
are merely resting on the wheels spokes damage may occur
if tightened. The
tips must be indexed into the wheel, between the wheels
spokes for secure attachment. The outer arms should close
in around the tire and wheel with the tips touching or almost
touching. Note:
The tension spring will aid in the attachment process.
5. When
the immobilizer is properly in position hold it in place
with one hand while you tighten the Secur-Bolt. Remember
to turn the Secur-Bolt clock-wise until the immobilizers
arm tips come
together or are positioned as close as possible. On some
installations the tips will not physically touch, however
the immobilizer will be securely attached when the secur-bolt
is tightened.
Remove Secur-Key, Insert bolt cutter resistant shank padlock
in bolt tube for additional security (Holes provided). Optional
Padlock and Padlock Cover available to fit your Rhino Immobilizer.
Optional cover prevents use of bolt cutters on padlock shank.
Creates a three tier tamper proof locking system.
6. Fill
out and attach the Immobilization Notice to the vehicle.
Place notice in plain view and in a conspicuous location.
7. REMOVAL:
Reverse the above procedure.
|
