2. Check to insure that the dome will fit down flush with the wheel, wheel trim disk or hub cap. If not you may have to remove the wheel trim disk or hubcap.

3. Pick up immobilizer with both hands, or as an alternative, place the bottom of the stand on the ground or pavement directly in front of the wheel you wish to attach the immobilizer to. Then follow steps 5, 6 and 7.

4. While holding the immobilizer arms open, slide the inner immobilizer arms tip along the inside of the tire until you feel the tip fall into place between the wheel and the wheels backing plate or wheel drum. Visually check or feel with fingers to insure that the immobilizers inner arm tip is in place and
engaged within the inner wheel. If the inner immobilizer arms tip is not properly engaged or is merely resting on the tire the Immobilizer cannot be properly installed. The tip must be indexed into the wheel between the wheels backing plate or wheel drum.

5. Engage outer dome against the outer wheel or hub cap as you perform the above procedure. Adjust the dome to properly center on the wheel as you bring it into position. Note: The tension spring will aid in the attachment process.

6. When the immobilizer is properly in position hold it in place while you tighten the Secur-Bolt. Remember to turn the Secur-Bolt clock-wise until the inner immobilizer arm and outer immobilizer dome is snugly attached to the wheel. It is normal for the self centering guide located on the inner side of the outer arm to bite into and dent in the tire at point of contact, this will not damage the tire. If you are immobilizing a vehicle with small tires leave the removable guide in place. If you are immobilizing a vehicle with large tires remove the removable guide. CAUTION: DO NOT OVER TIGHTEN AS YOU MAY DAMAGE HUB CAP OR YOUR MITI-RHINO BOOT. Remove Secur-Key, Lock cover by slamming it shut. Remove key. You should check the locking cover to insure it has properly locked. This procedure is simply accomplished by tapping the Secur-Key against the stop screw located on the top of the locking cover. Tap briskly in the direction the cover moves outward when opening. If it pops out check for debris or other and repeat the locking procedure.

7. Fill out and attach the immobilization Notice to the vehicle in plain view.

8 . REMOVAL : Reverse the above procedure .

2. Be sure you use the proper Immobilizer for the application, PB14 Standard size or PBRV14 for extra wide tires. Remove immobilizer guide located on the inner side of the outer arm of the immobilizer in order to install the immobilizer on larger wheels and tires, leave in place for smaller tires. Tractor Trailer, Semi and Truck models are also available. Refer to brochure or price list for wheel size and immobilizer model specifications. Feel free to call the factory or your nearest distributor if assistance is required.

3. Remove light gauge hub caps for secure installation directly to wheel. Make sure inner immobilizer arm tip is securely engaged and indexed into wheel between the wheels backing plate or wheel drum. Make sure that the dome maintains a centered position on the outer wheel during the tightening process and that the dome is tight against wheel or hub cap.

4. Keep Secur-Keys and lock keys in possession of trusted personnel.

1. Periodically lubricate lock with lock lubricant.

2. Occasionally or as necessary, lubricate Secur-Loc bolt with WD40 or similar lubricant.

3. Store in dry area whenever possible in order to prevent moisture accumulation and unnecessary corrosion of working parts.

4. Prevent damage to vehicles wheels by periodically inspecting and replacing the protective heading located on the immobilizers dome edge if it becomes damaged or is missing.