2. Check to insure that the dome will fit down flush with the wheel, wheel trim disk or hub cap. If not you may have to remove the wheel trim disk or hubcap.

3. Pick up Immobilizer with both hands, or as an alternative, place the bottom of the stand on the ground or pavement directly in front of the wheel you wish to attach the immobilizer to.
Then follow steps 4,5, 6 and 7.

4. While holding the Immobilizer arms open, slide the inner immobilizer arms tip (end) along the inside of the tire until you feel the tip fall into place between the wheel and the wheels backing plate or wheel drum. Visually check or feel with fingers to insure that the immobilizers inner arm tip is in place and engaged within the inner wheel. If the inner immobilizer arms tip is not properly engaged or is merely resting on the tire or backing plate or other the Immobilizer cannot be properly
installed. The tip must be indexed into the wheel between the wheels backing plate or wheel drum. The stop located on the outer side of the of the Indexing arm's tip will generally come in contact with the backing plate, wheel drum or tie rod end. This contact will prevent the immobilizer from continuing to rotate inward during the installation process.

5. Engage outer dome against the outer wheel or hub cap as you perform the above procedure. Adjust the dome to properly center on the wheel as you bring it into position. Note: The tension
spring will aid in the attachment process.

6. When the immobilizer is properly in position hold it in place with one hand while you tighten the Secur-Bolt. Remember to turn the Secur-Bolt clock-wise until the inner immobilizer arm and outer immobilizer dome is snugly attached to the wheel. It is normal and desirable for the self centering guide located on the inner side of the outer arm to dent in the tire at point of contact, this will not damage the tire.

7. Fill out and attach the Immobilization Notice to the vehicle. Place notice in plain view and in a conspicuous location.

8. REMOVAL; Reverse the above procedure.

2. Be sure you use the proper immobilizer for the application, HIO/H12/H14 fit Sub Compact, Compact, Standard size. Full Size Vehicles and Light Trucks, also most mobile equipment and boat
trailers. HRV12/HRV14 Fit Sub Compact, Compact, Standard size, Full size Vehicles, RVs and light trucks including those with extra wide tires and wheels, also most mobile equipment and boat trailers. Semi-Tractor, Trailer & Large Truck models are also available. Refer to brochure or price list for wheel size and immobilizer model specifications. Feel free to call the factory or your nearest
distributor if assistance is required.

3. Rarely, but occasionally, you may want to remove a light gauge hub cap for a more secure installation directly to wheel. If removed stow hubcap under automobile next to immobilized wheel or keep in other safe place. Make sure inner immobilizer arm tip is securely engaged and indexed into wheel between the wheels backing plate or wheel drum. Make sure that the dome maintains a centered position on the outer wheel during the tightening process and that the dome is tight against wheel or hub cap.

4. Keep Secur-Keys and Padlock keys in possession of trusted personnel.